Ladder Line | KV5R.COM
2015年7月5日 · To use for both 80 and 40 you will need to center-feed and run ladder line all the way, to a good 1:1 bifilar-wound choke/balun in or near the tuner (few feet of coax jumper is OK). If the doublet is cut for 80 (~130 feet), the impedance will be low on 80 (and a 4:1 would make it WAY too low), and very high on 40, where it’s 1 WL long.
Ladder Line Page 3 | KV5R.COM
2019年2月19日 · It’s a common misconception. The characteristic impedance of a feed-line is only meaningful when the line is terminated in a non-reactive (resonant) load with a feed-point impedance the same as the line, i.e., no standing waves. For example, a resonant folded dipole (300 ohm feed-point), fed with 300-ohm LL, and a 6:1 balun at the radio ...
Ladder Line - DX Engineering
Feed your multi-band dipole antenna with super-strong ladder line from DX Engineering. Ideal for high-frequency operation, our DX Engineering 300-ohm and 450-ohm ladder line offers great performance even when SWR is horrendous! Choose from 16 and 18 AWG line in a variety of lengths to meet your needs.
DX Engineering 450 Ohm Ladder Line
DX Engineering 450 Ohm Ladder Line is a transmitting grade low-loss parallel-wire RF feedline featuring a strong, waterproof, UV black polyethylene insulation. To maintain the wire spacing between the conductors while reducing losses, the integral flat plastic material alternates with rectangular openings, which explains the "Window Line" nickname.
Ladder Line Page 2 | KV5R.COM
2019年2月19日 · The “true” ladder-line is best called “open-wire feed-line,” or simply open-line, to distinguish it from window-line. This is the type made from two parallel wires, separated by spreaders. What to Get
Install Guidelines - True Ladder Line
Our TrueLadderLine is extremely low loss feed line which lends itself well to operating under high swr conditions. By using a single wire dipole antenna for multiple bands, the swr on the feedline will be high. With extremely low loss feed line such …
Feed Lines - ARRL
A popular type of feed line for HF use is ladder line. In fact, at HF frequencies it is the most common feed line for random-length dipoles and other antenna designs. Ladder line consists of nothing more than two wires in parallel separated by insulating material.
A review of QST article "The Lure of Ladder Line" - owenduffy.net
Ladder Line feed. On the advice of a peer, Steve then explored the same antenna with 15.2m (50') of ladder line. The article presents some predicted feed line losses at spot frequencies in the main HF bands. Figure 2 shows the results of modelling the ladder line feed configuration using 15.2m (50') of Wireman 551.
DX Engineering 450 Ohm Ladder Line DXE-LL450-CTL
DXE-LL450 450 Ohm Ladder Line is a high-quality flat RF feedline, about 0.938 in. wide (15/16") with two 16-gauge copper-clad steel wire conductors (29 AWG x 19 strands) that provide the strength to hold up for long spans between supports without twisting.
- 评论数: 45
450 Ohm - Ladder Line, Balance Line Dx Ham Radio Supply, Your …
450 ohm, #18, 19 strand copper clad steel ladder line, PE jacket. <1500W END OF RUN - #16 AWG; 19 strands Cu-clad with black poly jacket. Nominal OD .065 x .930; Extra flexible & less likely to break in the wind.